25C 11.1V 2200mAh LiPo battery w/ EC3

25C 11.1V 2200mAh LiPo battery w/ EC3

Features :

• Best choose for 3D flyer of Trex 400/450 and other similar size helicopters
• 25C high discharge rate will give you the power you can never think of. Long lasting and powerful.
• Continuous Discharge Rate: 25C / 55A
• Burst Discharge Rate: 50C / 99A
• Shipping weight: 1 pound

25C 11.1V 2200mAh LiPo battery w/ EC3 description

Features and Benefits Tenergy 25C 2200mAh 11.1V 3S Li-Polymer battery is the best choose for 3D flyer of Trex 400/450 and other similar size helicopters. 25C high discharge rate will give you the power you can never think of. Long lasting and powerful. * Continuous Discharge Rate: 25C / 55A * Burst Discharge Rate: 50C / 99A * Dimension: 103.5x 34x 25.5mm * Weight: 181g / 6.4oz Discharge (Output) Leads: 14 AWG silicon wire, 80 mm long, no connector Charging (Balancing) Lead: TP Style 4-pin connector. 24AWG PVC wire, 35 mm Long Note: Please read instructions before using!

Works in DJI Phantom Quadcopter (without XT60)
Just wanted to report in, I am up to three of these Tenergy packs for my Phantom and they work great. I purchased a set of Waltzmart XT60 connectors intending to swap out the connector because the Phantom uses XT60 and not EC3. However, to my surprise (and with a little patience) you can plug the EC3 male lead from the battery into the XT60 female lead on the Phantom. So I've been just using these batteries with the EC3 connector. Connection is very tight and I have no concern about the battery disconnecting in flight or anything like that. I will eventually replace the connectors with the correct XT60 style but right now I'm having too much fun flying to worry about it.

For the battery itself, it fits perfectly in the Phantom without modification and the battery door closes just fine. I get about 10 minutes flight time with these. I have three of these batteries and they all perform the same, they charge fine and work like batteries should.

I would recommend...