Hobbymate HB730 AVCS Gyro W/ Gotek D9257 Tail Rudder Servo for 450 500 Rc Helicopters
Features :
- Hobbymate HB730 AVCS Gyro for 450 500 Helicopters
- Gotek D9257 Tail rudder servo for 450 500 Helicopters
- Working frequency: 1520?s / 80 Hz Digital mode/Analog mode
- Gyro Operating Voltage: 4.8~6.0 Volts DC
- Dual rate gyro
Hobbymate HB730 AVCS Gyro W/ Gotek D9257 Tail Rudder Servo for 450 500 Rc Helicopters description
Dimension(mm):25x25x15 **
Weight: 20g **
Digital proportional R/C system **
Operating voltage:4.8V-6V (common for receiver) **
Operating temperature:-10?~45? **
Operating current: 80mA **
Functions: Minimizes changes in an aircraft attitude by wind **
Angular acceleration commands used **
Sensor vibration proofing **
Dimensions: 1.4 x 0.6 x 1.13" (35.5mm x 15.0 x 28.6mm)
Weight: 0.92oz (25g)
Torque: 3.8 kg-cm at 4.8V;
4.2 kg-cm at 6.0v
Operating Speed: 0.08 sec/60° at 4.8V
Lead Length: 7.9" (200mm)
Motor Type: Coreless Motor
Potentiometer Drive: Indirect Drive
Driver Type: FET
Bearing Type: Dual Ball Bearings
Gear Type: Plastic gear
Programmable: YES
Dead band: 0.002ms (Default)
Control System: +Pulse Width Control
Working frequency: 1520?s / 80 Hz Digital mode/Analogy mode
(Rx) Required Pulse: 3.0~5.0 Volt Peak to Peak Square Wave
Operating Voltage: 4.8~6.0 Volts DC
Works!!
I have several RC helis, They have been driven into the ground with a out of control tail. Now that I have this new Gyro, the tail boom is rock solid. the tail does not slowly turn away from you or randomly spin. I`m very happy with this product. The AVCS Gyro has made flying fun again. Thank You Hobbymate.
Update: NO ERROR on Gyro`s part, I have pile driven heli into asphalt. To my suprise the gyro still works great.
Update: And yet again severe damage to heli but gyro still going strong.
Update: ROFL finally. I have been able to ruin the gyro. It took a direct hit to housing at full speed. Watch out for those trees. :)
I Will order another Hobbymate HB730 AVCS gyro. It took an amazing amount of abuse before failing.



0 comments:
Post a Comment